MAINTENANCE
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
38
ZI-MD500HST
14.5
Clutch
As clutch wears out, the same lever could have a wider opening, being so uneasy to use. To enable
proper operation, the clutch cable must be adjusted:
1.
Loosen the jam nut (1) by turning it counter clockwise with 10
mm wrench.
2.
The clutch lever is set to the original position with the adjusting
nut (2).
3.
Then retighten the lock nut (1).
14.6
Steering
If you have difficulty steering the unit, you will need to adjust the steering levers with the special
adjusters.
1.
Loosen the jam nut (3) by turning it counter clockwise with 10
mm wrench.
2.
Unscrew the adjust nut (4) to eliminate the play in the cable,
which can occur after initial use or normal wear. Be very careful
not to unscrew the adjust nut too much because this can create
another problem: the loss of traction.
3.
Then retighten the lock nut (3).
If the above adjustment does not create enough cable tension, follow the steps below:
1.
Loosen the jam nut (5) by turning it counter clockwise with 10
mm wrench.
2.
Unscrew the adjustment nut (6) to eliminate the play in the
cable. (do not to unscrew the adjust nut too much because this
can create another problem: the loss of traction).
3.
Retighten the lock nut (5).
