Page 6 of 20
Zip HydroTap Installation and Operating Instructions - 82872 - July 2003
In addition to normal tools, the following will be required:
•
13.5 mm diameter sheet metal hole punch
•
35 mm diameter sheet metal hole punch.
Special tools required
Step A - Installing the tap (all models)
Locate the stick-on tap hole mounting template in the accessory envelope
and apply to a flat surface at the left rear corner of the sink. Follow the
instructions on the template.
Make sure that the tap will be able to drain into the sink.
Mark the two hole centres and cut the small hole using a 13.5 mm sheet
metal hole punch
Cut the large hole using a 35-mm sheet metal hole punch.
Install the tap, making sure it is adequately sealed.
To ensure proper sealing, make sure that the tap mounting items are
assembled in the order shown in the Assembly Detail diagram below.
Ensure that the upper plate is properly inserted in the recess on the
bottom of the sealing ring.
Tighten the fixing screws firmly.
Installation procedure
Tap Body
Base Ring
Sealing Ring
Upper Metal Plate (Fits into recess
in sealing ring)
Sink
Lower Metal Plate
Fixing Screws
Assembly Detail
