Page 26 of 28 802006UK BCS Residential User Guide - Aug 2015- V2.01
Air Inlet Filter
The HydroTap
®
G4 air filter is conveniently located on the outside of the
condenser. The filter screen is a sliding fit in the plastic housing on the left
hands side of the Command-Centre
TM
. The screen may be removed for
cleaning by sliding it forward. This needs to be inspected at least quarterly,
cleaned and replaced if damaged.
Note
For best performance the unit should only be operated with a clean
air filter screen, correctly fitted in place. Maintain at least a 50mm air gap
in front of the screen at all times. Take care not to allow cloths or other soft
materials to accidentally block the air inlet.
Warning: If the HydroTap
®
G4
is switched off for a long period
of time (e.g. more than a
weekend), run water through
the chilled water outlet for
at least five minutes before
consumption.
•
Caution.
A
small amount of water will drip as the cartridge is removed.
• Do not tilt the cartridge as water may spill from it if tilted.
• Unpack replacement cartridge and remove sanitary cap, write today’s date
where shown on the label.
• Avoid touching the filter o-rings and filter opening as this may cause
bacterial contamination of the cartridge.
• Moisten the o-rings with water, align the front cartridge label to the left (as
shown in the “insert filter” diagram below), and push the new cartridge up
into the filter head.
• Turn the cartridge a quarter turn anticlockwise until the cartridge comes
to complete stop and is locked into position, with the front label facing
forward.
• Initiate the filter flush programme by scrolling through the menu screen
(see page 15).
• When completed, wipe up any spills and dispose of spent filter cartridge
and packaging thoughtfully.
• Close the door to secure the appliance.
• Adjust the filter settings in Section G (see page 21) litres and days used.
Filter maintenance
Slide to remove