Zionair CP22S8, Инструкция по установке и эксплуатации, Страница: 13 / 32

12
6. Connect the earth wire (green-yellow) under P1 (fig.2) and the three phase wires under R, S
and T (fig.2). Check if all wires are properly connected.
7. Remove the big cover on the front of the compressor (2, fig.1).
8. Connect the compressor to the power supply and turn it on, check if the rotor of the
electromotor (1, fig.4) runs in the direction of the arrow (2, fig.4). If this is not the case, turn
of the compressor, remove the plug and swith two of the phase wires in the plug, than check
the running direction again.
Replacing the transport oil with Zionair compressor
oil
1. Drain all of the transport oil by means of the oil drain
bolt (1, fig.5) and place back the washer and bolt again.
2. Then loosen the oil fill cap (2, fig.5) and fill up the oil
with Zionair ADL100 compressor oil upto the middle of
the oil viewing glass (3, fig.5) till it reaches the red dot as
in figure 5.
Check before first use
1. Check if all bolts and nuts are firmly tightened and if the
transport bolts are removed.
2. Check the belt tension.
3. Check if all pipes look good and if there are no damages.
4. Check the oil level.
5. Check if the electrical wiring is not damaged.
6. Check the power supply and check if the power´s voltage is correct.
7. Whether the belt pulley is easy to rotate by hand.
8. Pay attention to following points:

Is the earth wire connected correctly?

Carefully read the entire manual.

Don´t hit, knock or bend any pipes

Do not come near the fan with hands and clothes.
Fig. 1 Fig. 2 Fig. 3 Fig. 4
Fig. 5