Decoder-Update-und-Sound-Loading devices MXULF, MXULFA Page 9
The
MXTAPS
(or
MXTAPV
) is connected to the output
“Schiene” of the
MXULF
via the double clamp
“SCHIENE”, and to a track output of a ZIMO central command station or another digital command station.
No additional supply is necessary.
If needed, the SUSI plugs from
MXULF
and
MXTAP
are connected: via “SUSI”, sound loading is essen-
tially faster than via “tracks”. For decoders with the interfaces “PluX”, “MTC”, “Next” as well as large-scale
decoders, SUSI is automatically available at the “SUSI” interface of the
MXTAP
and can easily be trans-
ferred to the
MXULF
.
Simultaneous sound loading
of more than one MX645P22 via “SUSI”: each decoder has to be con-
nected to an individual decoder-test-and-connection board MXTAP. Several
connection boards
can be
connected
in parallel
.
Typical application:
MXTAPV
with decoder MX644D (MTC interface), connected to
MXULFA
:
Supply of the combination via connection “Power” on the MXULFA, 2-pole cable from “Schiene”
(MXULFA) to “SCHIENE” (MXTAP); on the MXULFA, a
decoder update
was just started (according to
the display), the decoder software is loaded
from a flash drive
.
MXTAPV
(not MXTAPS) with connected large-scale decoder MX696, connected to
MXULFA
; on the
MXULFA
sound loading
was just started (according to the display), the sound project is loaded
from a
flash drive
.
MXTAPV
with decoder MX645P22 (PluX22), connected to
MXULFA
:
additionally
SUSI
cable between MXULFA and MXTAPV, for
faster sound loading via SUSI
, MXULFA
in this case is controlled
by computer
(usually software ZSP - ZIMO Sound Programmer; USB cable to
the computer; on the display information to communication between PC and MXULF).
MXTAPV
with decoder MX648N18 (Next), connected to
MXULFA
:
Via operating elements and display of the MXULFA,
test operation
is active, i.e. tests motor control,
function outputs, sound of the decoder.
NOTE: The
supply via SU-
SI cable is suf-
ficient for SUSI
sound loading!
ATTENTION:
only ONE connection can be used. Therefore, you can NOT connect more than one de-
coder to the number of interfaces of the
MXTAPS
or
MXTAPV
.
MX644
can
NOT
be loaded simultaneously!
