Zimmer PremoPortFour, Инструкция по эксплуатации, Страница: 4 / 48

Brief start-up instructions
C
Brief start-up instructions
Switch on PremoPort
Four
Hold down the Start/Stop button for at least 5 sec. The device is switched on
when the time appears on the LCD display. (e.g. 13:21)
Check voltage
Hold down the Start/Stop button for at least 5 sec. but less than 10 sec. While
the button is held down, the voltage is displayed (e.g. 2_23 corresponds to
2.23 V). Prior to starting measurements, this must be more than 2.5 V in the
case of rechargeable batteries and more than 3 V in the case of alkaline
batteries.
Connect PremoPort Four
with the PC
Find a free USB connection on the PC and insert the USB fibre optic
converter (11) into it.
Connect the fibre optic cable (9) to the USB fibre optic converter (11).
Ensure that the red mark on the cable matches the red mark on the USB
fibre optic converter (11).
Connect the other end of the fibre optic cable (9) with PremoPort
Four
by
inserting the small plug into the fibre optic cable connection (7) on the
device. Be aware that the red mark on the cable is located on the bottom
of PremoPort
Four
.
Interface configuration
Start the analysis software Diagnostik
Suite
on the PC and check and correct
the interface configuration in Diagnostik
Suite
, if necessary.
Select patient
Select the entry “Open” in the navigation area. Double-click to select the
desired patient.
Prepare examination
In the navigation area, open the “
New
” tab and, for a new ambulatory blood
pressure measurement, select “Prepare measurement”.
Transfer the patient data and the measurement plan to the PremoPort
Four
.
Record data
Disconnect the recorder from the PC.
Place cuff and device
Place the cuff with PremoPort
Four
on the patient. When placing the cuff,
ensure that the tube extends upwards and is guided behind the neck. Connect
the cuff to PremoPort
Four
. Start a manual measurement to test the function of
the blood pressure monitor.
Instruct patient
Instruct the patient on correct behaviour during the measurement and how to
operate the device properly.
Take back device,
read in measurement
data
After recording the examination, disconnect the cuff from the patient and
recorder and connect the recorder to the computer.
Start Diagnostik
Suite
and open the patient.
In the “
New
” tab of the navigation area, select “Read measurement”
in order to read the new examination into Diagnostik
Suite
.
After the data are transferred, they are displayed on the screen. To save,
press the “
Save
” button.
Switch off the examination device(s) and remove all accessories, such as the
blood pressure cuff, from the patient.