INSTALLATION AND OPERATING INSTRUCTIONS:
Collision protection, pneumatic, CSR series
Zimmer GmbH
•
Im Salmenkopf 5
•
77866 Rheinau,Germany
•
+49 7844 9138 0
•
+49 7844 9138 80
•
www.zimmer-group.com
10
EN / 2020-09-15
DDOC00267 / b
9 Maintenance
The CSR series product is maintenance-free.
The maintenance-free period may shorten under the following circumstances:
• Operation with compressed air that does not comply with DIN ISO 8573-1 [2:4:1]
• Dirty environment
•
Improper use and use that does not comply with the power specifications
• Observe the ambient temperature; lubricants harden faster!
Even though the product is maintenance-free as mentioned above, perform a regular visual inspection to check for any
corrosion, damage or contamination.
We recommend using Zimmer Customer Service for maintenance and the replacement of seals.
Dismantling and reassembling the product without authorization may result in complications, as special installation
equipment is required in some cases.
Zimmer GmbH shall not be liable in the event of unauthorized dismantling and reassembling of the product or in the event
of any malfunction or damage resulting from this.
10 Accessories/scope of delivery
INFORMATION
If any accessories not sold or authorized by Zimmer Group are used, the function of the product cannot be
guaranteed. Zimmer Group accessories are specifically tailored to the individual products.
Optional accessories and those included in the scope of delivery can be found at
www.zimmer-group.com
.
11 Transportation/storage/preservation
►
Transport and storage of the product must be done only with the original packaging.
►
If the product has already been installed on the superordinate machine unit, care must be taken during transport to
ensure that no unintentional movements can occur. Before commissioning the machine after transport, check all power
and communication connections as well as all mechanical connections.
►
If the product is stored for an extended period, the following points are to be observed:
• Keep the storage location as dust-free and dry as possible.
•
Avoid temperature fluctuations/observe and adhere to the temperature range.
• Avoid wind/drafts/water condensation formation.
• Pack the product and do not expose it to direct sunlight during storage.
►
Clean all components. There must be no soiling left on the components.
►
Visually inspect all of the components.
►
Remove all foreign substances.
►
Properly remove potential corrosion spots.
►
Close electrical connections using suitable covers.
12 Decommissioning and disposal
INFORMATION
When the product reaches the end of its operational phase, it can be completely disassembled and disposed
of. Completely disconnect the product from the power supply. The product can be disassembled and properly
disposed of according to material groups. When disposing of it, observe the locally applicable environmental
regulations and codes and regulations for disposal.
