9
Zikodrive Motor Controllers are a product of Round Bank Engineering Ltd
Floor 2, Clifton Warehouse, Sowerby Bridge, West Yorkshire, HX6 2BY
–
www.zikodrive.com
- +44 (0) 1422647177
Then change the COM port to the one you are using (
THIS WILL VARY FROM DEVICE TO DEVICE
–
contact
us if you are having trouble connecting to the COM port
). Set the BAUD rate to 57600, Data bits to 8, and
Parity to none.
5.
Once the Communication settings have been changed, you will need to open the port by going to
COM > Open. On the bottom left of the window, you should then see the COM port open with the
settings as below.
If you can see the COM port open and the settings as indicated in the image on the right then you have
now successfully connected to the controller and are able to set key parameters.
