TMU104V
12560-0702-02
Page
7 / 19
www.ziehl.de
Installation
The unit can be installed as follows:
•
Installation in switchgear cabinet on 35 mm mounting rail according to EN 60715 for protection against
fire, external environmental conditions and mechanical effects.
•
With screws M4 for installation on walls or panel. (additional latch is not included in delivery)
•
Connection according to connection plan or type plate.
Failure to comply with the information in this instruction manual will not guarantee the function of the device.
Putting into operation
9.1 General instructions for operation
The decimal point of the last digit shows the operating mode the device is in.
9.2 Display mode
•
Decimal point off (display value of measuring input)
9.3 Menu mode
•
Decimal point on
•
menu mode, select the menu items
Button Up / Down
Press short:
Selection of menu item; Change into display mode
Button Set
Press short:
Change into parameter setting mode
9.4 Parameter setting mode
•
Decimal point blinking
Button Up / Down
Press short/long:
Adjustment of parameter value (slow/fast)
Button Set
Press short:
Storage of setting and choice of next parameter.
Change into menu mode after the last parameter
9.5 Tips for operation
•
When the right decimal point in the 7 segment display is on, the display mode has been left, and the
menu items can be chosen with up/down (menu mode).
•
When the right decimal point blinks, you are in the parameter setting mode and can change the setting
with up/down.
•
In Parameter setting mode:
o
Long pressing on up/down speeds up the changes in the display.
o
Pressing button up and down at the same time sets values to zero.
•
With reset (press set/reset for 2s) the display mode can be reached from every position (exception:
simulation) of the parameter setting mode (the last selected value in is being stored).
The same happens when 30s no key has been pressed ((exception: simulation -> 15 minutes).
9.6 Switch on device
Switch on supply voltage,
All LEDs and displays are on. TMU104V is ready after app. 1 s.
9.7 Configure the sensor input
Starting from the display mode:
Return into the display mode by pressing Set key ≥ 2s
If no entry is made for 30 s, the device also returns to the display mode.
