Notice above. The FCC identi
fi
er is FCC ID: T7V1740. This FCC identi
fi
er is valid for all
PAN1740 modules.
In any case the end product must be labelled exterior with "Contains FCC ID: T7V1740"
Antenna Warning
For the related part number of PAN1740.
This device is tested with a standard SMA connector and with the antennas listed below.
When integrated in the OEMs product, these
fi
xed antennas require installation prevent-
ing end-users from replacing them with non-approved antennas. Any antenna not in the
following table must be tested to comply with FCC Section 15.203 for unique antenna
connectors and Section 15.247 for emissions.
Item
Part Number
Manufacturer
Frequency Band Type
Gain (dBi)
1
LDA212G3110K Murata
2.4 GHz
Chip-Antenna
+0.9
RF Exposure
The radiated output power of PAN1740 with mounted ceramic antenna (FCC ID:
T7V1740) is far below the FCC radio frequency exposure limits.
Nevertheless, the PAN1740 shall be used in such a manner that the potential for human
contact during normal operation is minimized
1.4.2 Industry Canada Certi
fi
cation @ AM-MODBUS-WB, AM-STICK-WB
This device contains "Contains IC: 216Q-1740".
PAN1740 is licensed to meet the regulatory requirements of Industry Canada (IC),
license: IC: 216Q-1740.
Manufacturers of mobile,
fi
xed or portable devices incorporating this module are advised
to clarify any regulatory questions and ensure compliance for SAR and/or RF exposure
limits. Users can obtain Canadian information on RF exposure and compliance from
www.ic.gc.ca.
This device has been designed to operate with the antennas listed in the Table above,
having a maximum gain of 0.9 dBi. Antennas not included in this list or having a gain
greater than 0.9 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms. The antenna used for this transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Due to the model size the IC identi
fi
er is displayed in the installation instruction only and
can not be displayed on the modules label due to the limited size (8.7x15.6mm).
IC Notice
The devices contains "Contains
IC: 216Q-1740
", including the antennas, which are listed
in above, complies with Canada RSS-GEN Rules. The device meets the requirements
for modular transmitter approval as detailed in RSS-GEN.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may
cause undesired operation
Quick Start Guide
AM-MODBUS-WB
General notes
L-BAL-E281-GB 2021/36 Index 004
Part.-No.
7/28
