4 Mounting
4.1 General notes
Attention!
The following points must be complied with during the mechanical installation to avoid
causing a defect in the device due to assembly errors or environmental in
fl
uences:
•
Before installation remove the device from the packing and check for any possible
shipping damage! Start-up is not allowed in the case of transport damage!
•
The installation in a switch cabinet or in a adequate plastic housing will be made
through a snap-up on a 35 mm top-hat-rail (EN 50 022) or through screw fastening.
•
Do not allow drilling chips, screws and other foreign bodies to reach the device
interior!
•
Do not mount equipment on vibrating base!
•
Care must be taken to avoid direct radiation from the sun!
4.2 Temperature in
fl
uences during commissioning
Avoid condensation in the controller and functional faults attributable to condensation by
storing the controller at room temperature!
Operating Instructions
NETcon
A-G-102ANE
Mounting
L-BAL-E156-GB 2105 Index 004
Part.-No.
9/32
