Ziegler & Brown KOMFORT, Руководство пользователя

Страница: 12 / 26

12
USING YOUR HEATER
FUEL
This heater uses wood pellet fuel only. Do not use any other type of fuel. The diameter should
be 6-8 mm, the length no more than 35 mm, moisture content no more than 10% and ash
content no more than 1%.
Please take care of the pellets. Do not dampen or crush it - this will affect the efficiency and the
dust will collect on the door glass.
Pellet quality is important. The performance of your heater is greatly affected by the type and
quality of wood pellets being burned. As the heat output of various quality wood pellets differs,
so will the performance and heat output of the pellet heater.
CAUTION: It is important to select and use only pellets that are dry and free of dirt or any
impurities. Dirty fuel will adversely affect the operation and performance of the unit and will void
the warranty. We recommend MAXIHEAT WOOD PELLETS for use in this appliance. These are
available from the outlet where you purchased your Ziegler & Brown heater.
Store pellets at least 1 metre away from the pellet heater.
ASH CONTENT
The ash content of the fuel and operation of your heater will directly determine the frequency of
cleaning. The use of high ash fuels may result in the heater needing to be cleaned daily. A low
ash fuel may allow longer intervals between cleaning.
CLINKERS
Clinkers are formed when dirt, ash or impurities in the fuels are heated to an extremely high
temperature and become glass like. These solid clumps are referred to as clinkers. The type of
fuel you burn can affect the occurrence of clinkers. Any fuel, even approved types, may tend to
form clinkers. Check the burn pot liner daily to ensure that the holes are not blocked with
clinkers.
ELECTRICAL
The use of a surge protected power board is recommended. The unit must be grounded
(earthed). The grounded electrical cord should be connected to a standard 2 4 0 volts (6
Amps), 50 hertz electrical outlet. Ensure that the electrical cord is not trapped under the
appliance and that it is clear of any hot surfaces or sharp edges and is accessible. If this power
cord should become damaged, a replacement power cord must be purchased from a
reputable dealer.
GLASS
Do not abuse the glass by striking or slamming the door. Do not attempt to operate the heater
with broken glass. Replacement glass must be purchased from an authorised dealer. Do not
attempt to open the door and clean the glass while the unit is in operation or if glass is hot.
FRESH AIR
An outside fresh air connection is optional. Consider all large air moving devices when installing
your unit and provide room air accordingly. Limited air for combustion may result in poor
performance, smoking and other side effects of poor combustion.