17
English
ASSEMBLY AND
INSTALLATION
Please refer to the illustra-
tions (
K
to
M
) provided at the
front and back of this manual.
For more information about
installation, see also
www.ritterwerk.de/
installation-notes.
Safety instructions
To avoid personal injury or
damage to the appliance,
please observe the following
safety instructions:
– This appliance may only
be assembled by qualified
personnel. ritterwerk will not
be held liable for the conse-
quences of improper and/or
incorrect assembly.
– The power cord must be
positioned to ensure that the
appliance can be fully folded
down into the drawer without
the cable becoming trapped.
The power cord must be
routed directly and without
obstruction from the built-in
system to the socket, which
must be mounted in the floor
unit.
– Unplug the cable from the
socket before assembly.
Installation conditions
The following dimensions rep-
resent minimum values:
– Drawer clearance width:
200 mm
– Clearance height for drawer
base/crossbeam: 75 mm
– Pullout clearance for front
edge of worktop/inner
edge of front drawer panel:
415 mm
– Clearance width (usable) for
drawer base: 184 mm
– Width of appliance (when
folded down): 178 mm
The drawer base should be at
least 16 mm thick.
At a nominal length of 500 mm,
the drawer runners should have
a static load capacity of at least
40 kg.
For body widths exceeding
300 mm, it is possible to devi-
ate from the minimum lateral
distance of 53 mm and centre
the toaster laterally within the
drawer.
Selecting a socket
Note:
A surface-mounted socket
(that complies with VDE/
DIN 49440, ÖVE, SEV)
must be mounted either on
or behind the rear panel at
drawer height.
The power cord connection to
the socket should be routed
under the rear crossbeam or
the underside of the work top
and as high up as possible in
the corner of the floor cabinet's
rear panel.
It must be possible to slide the
drawer in fully while the power
plug is in the socket.
The power plug must be eas-
ily accessible to the user to
ensure that the appliance can
be unplugged from the mains
as required (for example, prior
to cleaning).
Mounting the toaster
•
Pull out the drawer until it
stops.
K
Place the drill template in
the drawer as shown in the
illustrations.
•
Mark the positions for the
four drill-holes required.
•
Use a 1 mm drill to pre-drill
the marked positions.
L
and
M
Use the six coun-
tersunk screws provided (four
3 x 16, two 4 x 13; for a drawer
base of 16 mm) to mount the
holding fixture.
•
Mount the toaster in the
drawer as described in the
operating instructions.
•
Plug the cable into the
socket.
