13
Insert the red test lead banana plug into the positive
jack.
3.
Touch the test probe tips across
the circuit or part under test. It is
best to disconnect one side of
the part under test so the rest of
the circuit will not interfere with
the resistance reading.
4.
Read the resistance in the
display and then set the function
switch to the lowest
position
that is greater than the actual or any anticipated
resistance. The display will indicate the proper
decimal point and value.
CONTINUITY CHECK
WARNING:
To avoid electric shock, never measure
continuity on circuits or wires that have voltage on them.
1. Set the function switch to the position.
2. Insert the black lead banana plug into the negative
(COM) jack
Insert the red test lead banana plug into the positive (
)
jack.
3. Touch the test probe tips to the circuit or wire you wish
to check.
4.
audible signal will sound. If the circuit is open, the
display will indicate “1”.
DIODE TEST
