Zico SURE-GRIP SG-VM-1, Запчасти и инструкция по эксплуатации

Страница: 4 / 4

Ziamatic Corp.
10 West College Avenue, P.O. Box 337, Yardley, PA 19067-0587 • (215) 493-3618 • FAX: (215) 493-1401
*ZICO is a registered trademark for fire, safety and marine products made by Ziamatic Corp . Copyright Ziamatic Corp. 1-21
www.ziamatic.com
TOLL FREE: 800-711-3473
Page 4
Hook & loop pads
Note: Part numbers in parentheses (see Page 1).
I. INSTALLATION
1. The support arm on the Base (1) should be positioned toward the bottom of the
compartment, in both horizontal and vertical storage configurations.
2. When using two SURE-GRIP mounts to secure one tool, it is suggested to space the mounts
approximately shoulder-width apart to allow for quicker and easier operation
3. Attach Base to mounting surface using Truss Head Screws (5) combined with 1/4"
nuts (6) and washers (7)(10). If longer screws are needed, use low profile truss head
screws.
4. Adhere the Pad (9) to the flat portion of Base (see Page 3).
.
II. SECURING THE TOOL
1. Place and hold the tool against the Base. When in a horizontal configuration, support
arm may be used for assistance and stability.
2. Place the Strap (3) over the tool. Slide it behind the oval-shaped post from the side
(see above).
3. While maintaining tension on the strap, pull away from the Base to tighten, then
connect the hook pad and the loop pad to secure.
III. REMOVING THE TOOL
1. Grab the end of the strap at the red tab and pull away from the base to release the
hook & loop connection.
2. Pull the tool towards you, through the loosened strap. Strap will free itself as you
pull.
Oval-shaped post