Zico QUIC-LIFT PTS, Руководство пользователя

Страница: 7 / 28

-7-
C. One Actuator Running Two Seconds or More Slower Than the Other
All actuators are timed, under load, at the factory and the times are recorded. Electric
actuators are matched as close to equal times as possible when a PTS System is
assembled. When one actuator is running more than two seconds behind the other, it is
normally due to some type of resistance in the wiring system. Check all wire connections
to make sure they are secure. Make sure to ratchet both actuators at the end of each up
and down cycle. If they are still greatly out of synch after checking the wiring and
ratcheting the units at the end of each cycle, you may switch the actuators to confirm if
the problem is in the wiring system. With the portable tank removed, and the devices in
the lowered position, pull cotterless pins (34 & 35) and remove shelf arm casting (3). Remove
1/2" x 2-1/2" shoulder bolt (37) and 3/8-16 nut (38) to remove electric actuator (13).
Switch the two actuators and reassemble. If the rear actuator is running slower before
switching and is still running slower, there is a problem in the wiring.
VI. INSTALLING PORTABLE TANK COVER USING MODEL PTS-TCH
A. Preparation for Mounting
Follow installation instructions for the Portable Tank System (Section IV. A. & B.).
Particular attention must be paid to ensure that the center hinge (page 16) is in alignment
with the left and right casting sets.
Parts (page 18) and cover dimensions (page 19) are provided.
B. Mounting
Use the 1/2" hinge pin (114) for alignment. Shims may be required to correct adjust-
ment problems. All three pins should be aligned to within 1/16".
After the three hinges are aligned and the tank cover (page 19) has been fabricated,
you are ready to proceed with mounting.
NOTE: Measure the tank box (see page 19) to determine the "A & B"
dimensions. This will determine the size of your cover. The length of
the cover will also vary depending on the mounting distance between
the casting sets.
You are now ready to mount the tank cover and hardware as follows (refer to page 18
for item numbers in parenthesis):
1. Lay hinges (100) down along side of truck.
2. Place top of cover (115) onto the top of the tank boxes (9 & 10). You may have to
place temporary shims between tank cover and tank box to raise the cover. The bottom
edge of the tank cover should be just above the hinge (page 18 top right drawing).