Zico QUIC-LIFT PTS, Руководство пользователя

Страница: 4 / 28

B. Mounting the System (continued)
Check for any obstructions behind or below the selected mounting locations. Also be
sure you can run your wiring unobstructed through the back of the base castings. The
outboard ends of the devices cannot be obstructed as access is necessary for mounting,
emergency operation and adjustment of the actuators.
You are now ready to mount the devices as follows (refer to page 11 for item numbers
in parenthesis):
1. The flat surface, between the two ears on the base castings (1 or 2) should be
flush and parallel with the edge of the mounting surface. Both devices should be
parallel and in-line to within 1/16" of each other.
2. Pull cotterless pin (35) and lower shelf castings (4 or 5).
3. Mark eight base holes and lower two back holes. Remove devices.
4. Drill ten holes for 3/8" mounting bolts (not supplied). Replace devices, insert
bolts and snug up on nuts.
5. Pull cotterless pin (34) and remove shelf arm casting (3).
6. Lay electric actuator (13) forward and also lay back arm casting (6) forward.
7. Mark two top holes in base casting (if used). Also mark hole location for electrical
wiring through bottom rear of base casting.
8. Remove device and drill holes for the two top holes in base casting and for the
wiring.
9. Re-position devices on shelf and mount in place with 3/8" bolts and nuts.
10. Wiring should be run through lower hole in base casting at this time. We suggest
the wire be run in a protective sheath to prevent chaffing. The wire should be run
under the actuator adjuster casting (7) and up to the wire harness. Connection is
provided for mating to connector from the actuator.
11. Flip the back arm casting (6) and electric actuator (13) back. Connect wires
to actuator and check clearance through full swing of actuator. Replace shelf arm
casting (3) and pin the three units together using cotterless pin (34). Flip up the shelf
casting (4 or 5) and place cotterless pin (35) through the shelf casting and shelf arm
casting (3).
-4-