4
65
E
EMPTYING THE WATER RESERVOIR
In extreme circumstances it may be necessary to empty the internal water
reservoir. When the water reservoir is full, the transparent
1
/
2
- ring around the
button on the front of the device
flashes RED. To empty the water reservoir,
take the following action:
Do not move the device. This may cause water leakage.
First switch the device off and remove the plug from the socket.
Place a pan or container on the floor under the water drain
.
Remove the rubber plug from the water drain
and let the water drain out
(± 1 litre).
Insert the rubber plug back into the water drain
, push the plug into the
socket and switch the device on. The warning signal should now be off.
F
CONNECTION TO A PERMANENT DRAIN
First switch the device off and pull the plug out of the socket.
Place a pan or container on the ground under the water drain
in order to
catch any remnant water.
Remove the rubber plug from the water drain
.
Slide a water drain hose over the water drain
.
G
NOTES!
• Never use the airconditioner without the mesh filter!
• Using the device without the activated carbon filter and/or 3M
TM
HAF
filter will not damage the device. In this case, particles that may be
detrimental to health are not removed.
• Filter packages are available at your dealer.
• Only use suitable Zibro filters. This will prevent any damage to your
airconditioner. Using other than the original filters is entirely at the
risk of the consumer. This may have a negative effect on the
operation of the device and may result in damage. The device may
also leak water subsequent to the formation of ice.
1
2
3
4
5
G
NOTE!
Under normal conditions, the condensed water in the airconditioner is
removed via the air outlet hose.
1
2
3
4
man_Px2xx_1.qxd:man_P122-125.qxd5 22-12-10 15:56 Page 65
