Zibra corp ZC-LS006-1002, Руководство оператора, Страница: 8 / 16

8
Battery and Charger
Figure 4. Removing the Power Module and inserting and removing the Li-Ion Battery
The HLS
’s internal LED light source operates on a single, Lithium-ion battery and provides approximately 45
minutes of continuous operation with a fully-charged new battery. Use only Protected RCR123A (16340)
Lithium Ion (Li-ion) 3.7V Button Top Battery. This type of battery provides important internal PCB protection
against: Over-Discharge, Over-Charge & Short Circuit, which otherwise could be hazardous.
To insert a new battery, turn HLS to off position and pull Power Module out from the Heatsink/Handle, then
remove the old and install a new battery in the Battery Sled, making sure the
“+” end of the battery is inserted
in the correct orientation. Once a charged battery is inserted into the Power Module, reinstall the Power
Module by carefully aligning the key on the bottom of the Battery Sled with the keyway cut in the
Heatsink/Handle. NOTE: The key must be aligned with the keyway before full insertion is possible.
Please take care not to let the battery fall to the floor or onto a hard object, which could damage the battery.
CAUTION:
• Do not puncture or incinerate the battery. Contains explosive/flammable material.
• Do not expose the battery to high temperatures above 122ºF/50ºC
• Do not disassemble or short circuit the battery
• Do not use a damaged or leaking battery.
WARNING: The battery should be removed if the equipment is not likely to
be used for some time. Store battery in a cool dry location out of direct
sunlight.
Do not discard Li-ion Batteries in the trash, they must be sent to a recycling center. See
www.call2recycle.org or call 1-877-2-RECYCLE for the nearest drop-off location. This non-
profit Organization has over 30,000 drop-offs in North America.
Power Module
Battery Sled
Key is on the bottom
of the Battery Sled