SNE2-A2-ZN13-10
SNE2000G-P and SNE2000G-S
15
Important Safety Instructions
1
Read and follow all warning notices and instructions marked on the product or included in
the manual.
2
Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation
of the product and to protect it from overheating, these slots and openings must not be
blocked or covered.
3
Do not allow anything to rest on the power cord and do not locate the product where persons
will walk on the power cord.
4
Do not attempt to service this product yourself, as opening or removing covers may expose
you to hazardous voltage or to other risks. Refer all servicing to qualified service personnel.
5
General purpose cables are used with this product for connection to the network. Special
cables, which may be required by the regulatory inspection authority for the installation site,
are the responsibility of the customer. Use a UL Listed, CSA certified, minimum No. 26
AWG line cord for connection to the Digital Subscriber Line (DSL) network.
6
When installed, the product must comply with the applicable Safety Standards and
regulatory requirements of the country in which it is installed. If necessary, consult with the
appropriate regulatory agencies and inspection authorities to ensure compliance.
7
A rare phenomenon can create a voltage potential between the earth grounds of two or more
buildings. If products installed in separate buildings are
interconnected
, the voltage
potential may cause a hazardous condition. Consult a qualified electrical consultant to
determine whether or not this phenomenon exists and, if necessary, implement corrective
action prior to interconnecting the products.
8
Input power to this product must be provided by one of the following: (1) a UL Listed/CSA
certified power source with a Class 2 or Limited Power Source (LPS) output for use in
North America, or (2) a certified power source, with a Safety Extra Low Voltage (SELV)
output having a maximum of 240 VA available, for use in the country of installation.
9
In addition, since the equipment is to be used with telecommunications circuits, take the
following precautions:
— Never install telephone wiring during a lightning storm.
— Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
— Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
— Use caution when installing or modifying telephone lines.
— Avoid using a telephone (other than a cordless type) during an electrical storm. There
may be a remote risk of electric shock from lightning.
— Do not use the telephone to report a gas leak in the vicinity of the leak.
Contacting Global Service and Support
Contact Global Service and Support (GSS) if you have any questions about this or other Zhone
products. Before contacting GSS, make sure you have the following information:
z
Zhone product you are using
z
System configuration
z
Software version running on the system
z
Description of the issue
!
