Zgonc 935-33, Перевод оригинального руководства пользователя

Страница: 32 / 36

32 | GB
13. Troubleshooting
Supposed malfunctions, errors or damages are often caused by events which can be remedied by the operator.
Therefore check the power tool on the basis of the following table before you contact a specialist. Many malfunc-
tions may thus be remedied.
Problem Possible cause Approach
Power tool does not
start
Power supply interrupted Check power supply by connecting another
power tool
Power cord or plug defective Have an electrician check the tool
Other electrical defect of the power tool Have an electrician check the tool
Power tool does not
operate with full power
Extension cord too long and/or cross-
section too small
Use extension cord with permissible length
and/or adequate cross-section
Power supply (e.g. generator) voltage
too low
Connect power tool to an appropriate power
supply
Poor operation results Power tool worn out Replace insertion tool
Grinding plate worn out Have grinding plate replaced
Considerable dust
formation
Brush edge worn out Have brush edge replaced
Dust extraction not connected /
switched on
Connect / switch dust extraction