Maintenance and Installation Instructions
Edition 11.07.2006
15 of 30
Mounting of the gear ring GK 40
1. Place the steering turntable (Item 01) and rotate it so that the boltholes in the steering turntable
align with the threaded holes of the transmission top section (Item 02).
2. By means of a plastic tip hammer install the steering turntable until contact and position it with
the cyl. pins 8m6x20 (Item 03).
3. By means of the cap screws M8x20 (Item 04) fasten the steering turntable onto the transmission
top section.
Figure 11
Demounting of the pivoted connection
Demounting of the pivoted connection is basically made in reverse order of the mounting.
Checking of fixing bolts of the pivoted connection
The fixing bolts of the pivoted connection (see Fig.05 Item 04) have to be checked at regular intervals,
especially in case of:
•
high breakdown torque load or
•
hanging axial load
After the first 100 operating hours the fixing bolts have to be checked and in
case of deviation tightening to the specified value is required! (34 Nm)
Check the fixing bolts always after 600 operating hours, however, half-yearly
at least! In case of special operating conditions or device-dependent
inspection specifications the intervals can be reduced accordingly.
Disregard might cause personal injury or damage on the product!
03
04
02
01
