ZF Duoplan 2K801, Руководство по эксплуатации

Страница: 11 / 30

Operating Instructions
2K800/2K801/2K802 Initial Installation
EN 4161.758.103m – 2015-10 11
3 Initial Installation
3.1 Axial runout, radial runout and length
tolerances – drive motor
In order to guarantee fault-free operation, the
motor must not exceed the specified tolerances.
Axial runout, radial runout and length tolerances –
electric motor mounting flange:
Gearbox
type Tolerance
A B C L=140
2K800/
2K801 0.030 0.063 0.063  0.200
A B C L=140
2K802 0.030 0.063 0.063

0.200
Tolerances A, B, C to DIN 42955R
Please note that the tolerance of the shaft length
“L” is restricted in relation to the DIN standard
CAUTION
The special tolerance for shaft length “L” must
be maintained in order to guarantee fault-free
gearbox operation. Undersize shafts must be
compensated for by using shims when mounting
to the motor. Oversize shafts must be machined
to the correct length.
Take into account the motor shaft elongation
caused by heating in motors with fixed bearing on
the B-side (opposite the motor output shaft).
A B C
L
001064