Zetta ZIR32 Infrared HD Security Camcorder Quick Start Guide
www.zetta.com.hk
(9) A. Ext-Trigger In Contact Type - Normal Open
Instructions:
1. Run Zetta Widget->Choose Option-> Custom Mode->Save Option, then choose Settings->
Ext-Trigger In Contact Type-> Normal Open and press Sync Settings to DVR
2. Put the mode switch to the custom mode position
3. Connect ZIR32 to the external device (suggest using AWG26 wire). The connector screw is
on the top of ZIR32.
ZIR32 Trigger in +(Pin3) should connect to external device Trigger out +.
ZIR32 Trigger in - (Pin4) should connect to external device Trigger out -.
4. Turn on ZIR32 after connecting the wire correctly.
Operation:
Standby
If no trigger is detected by external device, the trigger out of external device will be kept
open. ZIR32 operates in standby mode.
Triggered
The external device outputs will be connected after triggering. ZIR32 will start recording
immediately at the same time.
B. Ext-Trigger In Contact Type - Normal Close
Instructions:
1. Run Zetta Widget->Choose Option-> Custom Mode->Save Option, then choose Settings->
Ext-Trigger In Contact Type-> Normal Close and press Sync Settings to DVR
2. Put the mode switch to the custom mode position
3. Connect ZIR32 to the external device (suggest using AWG26 wire). The connector screw is
on the top of ZIR32.
ZIR32 Trigger in +(Pin3) should connect to external device Trigger out +.
ZIR32 Trigger in - (Pin4) should connect to external device Trigger out -.
4. Turn on ZIR32 after connecting the wire correctly.
Figure 3
Operation:
Standby
If no trigger is detected by external device, the trigger out of external device will be kept
connected. ZIR32 operates in standby mode.
Triggered
The external device outputs will be opened after triggering. ZIR32 will start recording
immediately at the same time.
(10) A. Aux-Trigger Out Contact Type - Normal Open
Instructions:
1. Run Zetta Widget->Choose Option-> Custom Mode->Save Option, then choose Settings->
Aux-Trigger Out Contact Type-> Normal Open and press Sync Settings to DVR.
2. Put the mode switch to the custom mode position.
3. Connect ZIR32 to the external device (suggest using AWG26 wire). The connector screw is
on the top of ZIR32.
ZIR32 Trigger out +(Pin5) should connect to external device Trigger in +.
ZIR32 Trigger out - (Pin6) should connect to external device Trigger in -.
4. Turn on ZIR32 after connecting the wire correctly.
Note: 1. Please make sure the voltage input to ZIR32 trigger out +(Pin5) is under
24V and the current is less than 1A.
2. Please make sure the current direction is correct. Otherwise, ZIR32 may
be damaged.
Figure 4
7
8
