SIMPLICITY PLUS / SIMPLICITY MICRO – ADDITIONAL FEATURES.
Software Version :PANEL-R6180 (Plus) R5780 (Micro)
Approved Document No: GLT.MAN-139
PAGE 3
Issue 1.00 Authorised: GH Date: 02/06/2010
2. Reporting new Devices found
1 After the system has been installed, and the cabling checked and the addresses of
each device set, connect the loop to the fire alarm panel and power up the system
(mains & batteries). It should say “system normal, and only the green Power LED will
be lit. After a few seconds, the panel will find all the new devices & report them
unconfigured
2. Press the enter button to configure the loop. The panel will show Configuration
in progress for about 9 seconds, then it will then return to the system normal screen.
The loop is now configured.
3. Reduced Loop Simplicity Panels
For the reduced loop capacity Simplicity panels (EG Simplicity Micro, or Simplicity
Plus 64), it is possible to address a device outside the panels range. Previous versions
of simplicity panel would expect the user to find this problem by checking the device
contents screen, and comparing to system drawings, but this latest version will warn
that there are devices outside the panels address range, and help identify them.
Configuration in
Progress
Please Wait
Devices Found
Press ENTER to
Configure Panel
Devices Outside
Address Range
ENT to turn on LED
