PREMIER QUATRO USER MANUAL, MAINTENANCE GUIDE & LOG BOOK (Fyreye MKII)
#Doc No. GLT-215-7-2
PAGE 7
Issue: 1.08 Author: TE/NJ Date: 26/05/2017
The only functions that can be performed by the user when the panel is in the normal or quiescent state are:
Ending a programmed delay when the panel is in alarm. For example, if the installation engineer has instructed the panel
to wait for 2 minutes after a fire has been detected before sounding the alarm, a user can override this delay if it is
obvious that the building needs to be evacuated immediately. The user can override the delay by pressing button F4
(above which is displayed [END DELAY] on the screen).
Putting the Panel into the Controls Enabled state – see below.
ii. CONTROLS ENABLED
This access level is obtained by turning the access control key to the controls enabled position. When the controls are enabled you
can start or stop the external sounders, silence the panel’s internal buzzer, or reset the panel. The numeric keypad is also enabled
which allows the codes to be entered for the user’s password or the installation engineer’s password.
iii. USER MENU – FOR EACH AUTHORISED USER OF THE PANEL
This access level is obtained by entering a password which has been assigned to an authorised user. The password is 4 digits long.
The initial default password value is 1111. It is recommended that this is changed for the authorised users by the installation /
commissioning engineer, to make the panel more secure. Here the user can view panel, loop, and zone and event log contents; read
individual points (i.e. detectors, call points, sounders & I/O’s); disable / enable zones, points, sounders and relays; cancel
programmed delays; and test the LEDs and LCD. The user can also enter the test mode, which permits points in selected zone(s) to
be tested without causing the alarm to be raised throughout the building.
iv. INSTALLER MENU – FOR INSTALLATION / COMMISSIONING ENGINEERS ONLY
This access level is entered via the installation / commissioning engineer’s password. At the installer level, the engineer can set up
or modify a panel’s site configuration, and use the available menus to fault find the alarm system. The engineer’s password must
not be revealed to the users.
4.5 CHECKING THE PANELS INDICATION LEDS
Turn the key switch to “Controls Enabled” position, and enter the 4-digit User password. Use the
▼
button to scroll down the menu
to Test LEDs & LCD. Press the
ENTER
button. All the LEDs on the front panel will light, the LCD screen will fill up with black squares,
and the internal buzzer will sound. After about a second all these events will automatically reset.
4.6 WHAT THE LEDS MEAN
The LEDs on the Quatro can be grouped into the following sections:
General Indications:
These are indications to specific conditions, such as power, power supply faults, Earth faults, double address, system fault etc. They
indicate all conditions except those that relate to the zones & sounders.
Common Indications:
These are Common Fire & Common Fault. These will light in conjunction with another LED which indicates the fire or fault
condition, as a backup indication. They do not represent a specific event.
Zone Indications:
These are used to show a fire, fault, test mode, or disablement on a zone.
Mode Indications:
These are used to show which mode the panel is in. The controls active LED shows if the controls are enabled. The general test &
general disablement are used to indicate test mode & disablement mode, respectively.
