Zero ZCCC-222.GX, Инструкция по эксплуатации

Страница: 11 / 17

CID
HOW TO LIGBT THE BURNER:
TO LIGHT YOUR STOVE IN A SAFE MANNER ACCORDING TO THE
FOLLOWING STEPS
FOR TOP BURNERS
•
1 . Push the proper gas valve handle in and tum counter - clockwise to
Fully-open position to light the bumer.
•
2 . Once the humer is lit, you can adjust the intensity of flame desired.
FOR OVEN:
•
1 . Light and pull out the bottom oven tray, push the gas valve handle in and tum
Counter-clockwise to fully-open position to light the humer
•
2. Keep the handle depressed for 10 seconds.
•
3. If the humer does not stay
lit,
repeat procedures .
•
4. Before lighting or re-lighting, wait for
S
minutes with all gas shut off.
•
5 . To shut off, turn all valves to "OFF" position .
OPERATION:
Please pay attention to the/ollowing issues during operation:
•
Before operation , please make sure that the appliance isput in a horizontal
position
•
Keep 80cm around the item clearance and 1.Sm at least away from flammahle or
explosive materials
Â.
WARNING :Obstructing combustion air opening will cause non-efficient
combustion and high level of exhaust gas
•
After you have ignited the gas stove and/or oven, you can adjust the
control knob, which as the drawing shows, for your
@)
ideal flame and temperature you want. (Drawing 1)
•
When you could not ignite the flame, or the flame
becomes short, or the yellow flame occurs, please check
t.t. (\
whether there is enough gas in the cylinder .
ŒD
t.
•
After finishing cooking , please wear gloves and take the
(Drawing l)
pan
from gas stove or take food from the oven, special attention is required since
the appliance is hot
•
The gas humer has been set by the producer . Do not try to remove or adjust it.
•
The food put on the oven shelf could not exceed Skg
•
Do not move the appliance during operation
•
Do not use this appliance if it is leaking, damaged, or does not operate properly