Zero ZCCC-222.GX, Инструкция по эксплуатации

Страница: 7 / 17

INSTALLATION:
For the correct 11ssembly of the outb11ck camp stove. Follow the
Instructions below:
•
1 . Remove the paper between wire pan-grate and stove panel. Put the wire
pan-grate in its position. Be sure that the wire ends fitwell in the proper
holes on the top to prevent the rack from moving.
•
2. Open and close the burner valves: to operate the valves, you must push the
valve handle in and tum counter-clockwise to open and clockwise to close
•
3 . Be sure that the burner valves are in the "OFF" position before you
connect the stove to a gas or propane supply line .
Notice : This stove may be used with a 20-LB propane cylinder, a 1-LB
disposable cylinder. To use with propane, the proper low-pressure
regulator and hose must be used.
Notice : A qualified installer, serive agency or the gas supplier should perform
installation. For the correct installation of the stove, please follow the
steps indicated below :
•
4.Connect the inlet of the stove with the outlet of the gas regulator. This
connecton must be made with a specialised hose for LP gas.
•
5. Be sure that the hose is placed correctly and is not being stretched, tied,
or bent.
•
6. Also be sure that the hose is not too close to heat sources, especially with the
back of the camp stove .
•
7 . It is recommended that a manual gas valve is placed between the gas
pressure regulator and the inlet of the stove to open or shut off the gas
supply . This valve must be in an easily accessible location.
•
8 . Be sure that the stove is correctly installed . Check for any leakage,
mix some water with soap, pour some over each connection and look for any
bubbles, the bubbles indicate a leak, try to tighten connection and check
again, if the leak still appears, replace the connection .
.3.