zero
HOME AUTOMATION
Z01 - SLIDING GATE
PG8
Problem
Procedure
Behavior
Procedure II
Door doesn’t
work
Make sure you have 230V
power supply connected
to control board and if it
is working properly.
Still not working.
Consult a qualified ZERO
technician.
Motor doesn’t
move but makes
noise
Unlock motor and move
the gate by hand to check
for mechani cal problems
on the movement
Encountered problems?
Consult an experienced
gate expert.
The gate moves easily?
Consult a qualified ZERO
technician.
Motor opens
but doesn’t
close
Unlock motor and move
the gate by hand to closed
position.
Lock motor again and turn
off power supply for 5 se
-
conds. Reconnect it and
send start signal using
transmitter.
Gate opened but didn’t clo
-
se again.
Check if there is any obsta
-
cle in front of the photo-
cells;
Check if any of the control
-
devices (key selector, push
button, video intercom,
etc.) of the gate are jam
-
med and sending perma-
nent signal to control unit;
Consult a qualified ZERO
technician.
Gate doesn’t
make complete
route
Unlock motor and move
ate by hand to check for
mechanical problems on
the gate
Encountered problems?
Consult an experienced
gate expert.
The gate moves easily?
Consult a qualified ZERO
technician.
05. TROUBLESHOOTING
