zero
HOME AUTOMATION
Z01 - SLIDING GATE
PG6
It is very important that these dimensions are respected! Only this way can be
assured the correct functioning and durability of the operators!
During the course of the gate, all elements of the rack must mesh properly with
the pinion! All rack supports must be weld at the gate. Do not use mass or other
types of lubricant between rack and pinion!
• FLASH LAMP
• ANTENNA
• CONTROL
BOARD
• MOTOR
• PHOTOCELL
• PHOTOCELL
• KEY SELECTOR
TIPICAL INSTALLATION
It is important to use mechanical stoppers in the opening and closing position of
the gate. If not respected, components of the automation may suffer efforts for
which they were not prepared, and as a result will be damaged.
It is important to use junction boxes for connections between motors, components
and control unit. All cables must enter and exit on the bottom of the junction and
control board box.
