zero
HOME AUTOMATION
Z01 - SLIDING GATE
PG7
MANUAL RELEASE
To open manually the gate in case of electric power failure or in case of damage, follow the
below steps:
01. Open the protection cover to acess the key
hole for the release. Insert the key and turn
it 90°.
02. Pull the lever towards the outside, and
you can now open/close the gate manually.
NOTE
: So that the automation will operate
normally, close the unlock and turn the key to
the original position.
Check that the distance between rack and motor remains unchanged and this engages the teeth
of the pinion of the engine correctly (over time can happen some distortion).
Lubricate all systems/axis of movement of the gate. Lightly lubricate with spray the rack and
pinion.
Periodically check the amount of oil within the operator. For medium-low frequency of use, an
annual check is enough, for more intensive use it is recommended every 6 months. To make
filling, unscrew the cap and load until the level.
04. MAINTENANCE
Check all screws of the automation such as the fixing plate to the ground, the plates
of the limit switches, motor and the gear rack.
ADJUSTING THE TORQUE TRANSMISSION
To adjust the torque transmission, act on the
screw placed on the engine:
- Rotate the screw clockwise to Increase the
torque transmission.
- Rotate the screw anticlockwise to decrease
the torque transmission.
CAUTION:
THE MOTOR IS PROVIDED WITH
THE CLUTCH REGULATED AT MAX. SHOULD BE
ROTATE ANTICLOCKWISE THE SCREW, UP TO
ACHIEVE THE OPTIMAL ADJUSTMENT.
