BNP
®
65 and 220 SUCTION BLAST CABINETS
Page 11
© 2019 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 21309, Rev. J 01/19
Track support table.
Turntable and workcar assembly.
Figure 12
NOTE: The track may be placed on either side of the
cabinet, allowing entry through either the right side or left
side door; the right side is shown in the illustrations.
When installing the inside track, place it so the stops,
shown in Figure 13, are opposite the entry door.
3.5.2
Place the inside track in the cabinet over the
existing grate, as shown in Figure 13.
Figure 13
3.5.3
Position the track support table and extension,
as shown in Figure 14. When the hinged extension is
lowered, the extension tracks must rest on the angled
locating supports welded to the bottom of the inside
tracks, and it must butt against the inside tracks.
3.5.4
Loosen the leveling-pad lock nuts and raise or
lower the pads, as needed to adjust the height of the
table, to make sure that the inside and outside tracks are
aligned, that the hinged extension rest evenly on the
support angles when the extension is lowered, and that
the table is level.
3.5.5
Raise the track extension, and then open and
close the door to make sure they function correctly.
When certain the table and tracks are aligned and level,
and that the workcar moves smoothly on all tracks,
tighten the leveling-pad lock nuts and anchor the support
table to the floor through the holes in the leveling pads.
Figure 14
3.6
Optional Externally Adjustable Vortex Cylinder
Not available for 300 cfm reclaimer.
3.6.1
The externally adjustable vortex is an option
when the cabinet is provided with a CDC-1 Dust
Collector. The vortex is standard with 600 cfm and 900
cfm reclaimers when the cabinet is provided from the
factory with an RPC-2 or RPH-2 Dust Collector.
4.0
OPERATION
NOTICE
Do not pulse new dust collectors or
replacement cartridges until the cartridges are
properly seasoned, as instructed in the dust-
collector owner’s manual. Pulsing unseasoned
cartridges can decrease the efficiency of dust
collectors and cause premature cartridge failure.
4.1
Media Loading
4.1.1 Media capacity:
The approximate capacity and
minimum media amount is shown in the table below.
Reclaimer Size Minimum Wt.
Capacity
300 cfm
10 lbs
50 lbs. (0.5 cuft)
600 cfm
20 lbs
75 lbs. (0.75 cuft)
900 cfm
30 lbs
100 lbs. (1 cuft)
Inside Track
Hinged Track Extension
Track Support Table
Turntable and Workcar
Stops
Entry Door
The hinged extension
must rest on the
inside-track support
angles when lowered.
Support Angles
Grate
Anchor Holes (4 places)
Leveling Pads (4)
