Fitting Instructions
Zero 88 reserves the right to make changes to the equipment described in this manual without prior notice.
This equipment is designed for professional stage lighting control, and is unsuitable for any other purpose. It should be used by, or under the supervision of, appropriately
qualified or trained persons only. E & OE
Servicing of this equipment should be attempted by suitably qualified persons only.
Zero 88
Usk House, Llantarnam Park, Cwmbran. NP44 3 HD U.K.
Tel: +44 (0) 1633 838088 Fax: +44 (0) 1633 867880
Email:
Web:
www.zero88.com
Issue: 01
Date:29/06/07
Doc. No. 7327500/Fi8319
4.
Remove and retain the three screws A, B and C shown in fig 3. Replace these screws with the
three hexagonal metal spacers supplied.
Fig 3 – Fixing holes used and mating connector positions
5.
Before fitting the SMPTE/MIDI/CAN/Remotes Upgrade PCB, make sure that the plastic nuts and
washers have been removed from the two audio jack connectors. Retain these nuts and washers.
Carefully assemble the SMPTE/MIDI/CAN/Remotes Upgrade PCB by poking the connectors
through the holes in the rear of the metal base, slightly flexing the three long pin connectors so that
they line up with the three mating connectors on the processor PCB and pushing the connectors
together. Fit the previously retained screws A, B and C through the fixing holes in the
SMPTE/MIDI/CAN/Remotes Upgrade PCB and into the hexagonal metal spacers (see fig 4).
Fig 4 – Assembled SMPTE/MIDI/CAN/Remotes Upgrade PCB
C
B
A
Mating
Connectors
