Fitting Instructions
Zero 88 reserves the right to make changes to the equipment described in this manual without prior notice.
This equipment is designed for professional stage lighting control, and is unsuitable for any other purpose. It should be used by, or under the supervision of, appropriately
qualified or trained persons only. E & OE
Servicing of this equipment should be attempted by suitably qualified persons only.
Zero 88
Usk House, Llantarnam Park, Cwmbran. NP44 3 HD U.K.
Tel: +44 (0) 1633 838088 Fax: +44 (0) 1633 867880
Email:
Web:
www.zero88.com
Issue: 01
Date:29/06/07
Doc. No. 7327500/Fi8319
Fitting Instructions
1.
Ensure that the desk is switched off. Disconnect the power supply unit and all cables. Turn the
desk upside down and rest on suitable supports (e.g. foam rubber).
Do not rest the desk on the
control knobs as this may damage them.
2.
Remove the five screws that secure the blanking panel to the rear of the desk and remove the
blanking panel (see fig 1).
Fig 1 – Blanking Panel
3.
Remove the four screws, two either side of the desk, that fix the base to the side panels (see fig 2).
Retain the screws. Lift the base slightly and then pull it towards the rear of the desk so that it
comes out of the groove in the underside of the desk.
Fig 2 – Base panel fixing screws position
1 screw towards front
(both sides)
1 screw towards rear
(both sides)
Blanking panel
