Zepro Z 1500-135, Руководство по установке

Страница: 35 / 62

Z/ZL 1500/2000-135/155/175 Cable routing
35 www.zepro.com
5.5 Warning lighting/foot controller
If the tail lift is equipped with warning lighting and/or foot controller, their cabling must be routed and con-
nected according to the following description.
1. Connect the supplied cable to the connector on the foot controller/warning lighting cable.
2. Route the cable and install with cable ties according to Figure 54 and Figure 55. The quick connector must be
positioned in such a way that it does not conflict with the underrun protection while the 1st boom is in motion.
Measure the distance (A) from the centre of the lift arm shaft to the centre of the underrun protection; see
Figure 56.
3. Measure the same distance (A) on the lift arm; see Figure 56.
4. Then place the quick connector at least 100 mm outside or inside the measured point (B); see Figure 56.
Connection is described later in section 6.
Figure 53. Warning lights and foot controller
Route the cable between the platform and the lift arm tube such that it is well protected when the platform
touches the ground.
Position the quick connector in such a way that it does not conflict with the underrun protection while the
lift arm is in motion.
Leave enough slack to the first cable tie to avoid the risk of damage to the cable during lift operation.
NOTE!