Z/ZL 1500/2000-135/155/175
26
Installation
www.zepro.com
2
3
5
4
End stop
Adjusting collar
Lock screw
NOTE!
It is necessary to adjust the tilt angle 90º to the body
before adjusting the tilt down angle (see previous page).
m
WARNING!
To make sure the lift is safe and CE compliant, the
downward tilt angle must be adjusted to max 10° if
people will be present on the platform.
1. Run the lift up until the platform reaches the
vehicle floor.
3.6.
2. Loosen the lock screw of the end stop (2). Screw
the stop all the way back toward the platform (3).
Figure 29.
3. Tilt the platform down to max 10 degrees below
the horizontal plane. 3.6.
4. Adjust the end stop all the way to the top of the
cylinder (4). Figure 29.
5.
Tighten the locking screw in the stop (5). See figure.
Figure 29.
Tightening torque for the locking screws is 3-5 Nm
Test all functions.
4.2.2 Adjusting tilt-down angle
Bolt
Washer
Figure 42.
The tilt angle must be ad
-
justed to max.10° down
Figure 43.
End stop with lock screw
Figure 44.
Tilting cylinder
Содержание Z 1500-135
Страница 2: ......