Zeppelin Design Labs QUAVERATO MIDI MOD, Руководство по сборке

Страница: 11 / 21

11
b. The leads on this IC are too short to bend out to hold the chip in place. A good way to install
this component is to tack in one pin from the top of the PCB and then turn the board over to
solder the rest of the pins (15,16). Don’t forget to re-solder the tacked pin from the bottom.
The pins are too short to snip off so you can leave them.
15 16
9. 1/8” TRS Audio Jack (J1): Install the 1/8” jack at J1. Make sure all the pins on this jack are
straight. Line up the pins to the slots in the PCB and press the jack snug to the board (17,18).
While holding the jack in place, flip the board over and solder the pins (19).
17 18
19