Zephyr Elica Om, Инструкция по использованию, уходу и установке

Страница: 17 / 24

17
www.zephyronline.com
Controls
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes
approximately after terminating cooking.
Light touch sensor key: dim lighting / full lighting /off (loop control) - Works even with hood in stand by/OFF
ON/OFF Intensive speed selection touch sensor key (suction power) - lasts 5 minutes - press again to return to
previous setting.
High-speed selection touch sensor key (suction power).
Medium-speed selection touch sensor key (suction power) - when flashing it indicates the need to wash or
replace the carbon filter. This signal is normally deactivated. Press sensor keys 1 and 2 at the same time to
activate. At first only key 1 will flash, then both keys 1 and 2 to indicate activation. Repeat the operation to
deactivate the signal. At first keys 1 and 2 will flash, then only key 1 to indicate deactivation.
Low-speed selection touch sensor key (suction power) – when flashing it indicates the need to wash the metal
grease filter.
Motor touch sensor key OFF (stand by) – excludes the electronics – reset wash/replace filters signals.
MOTOR OFF
Hood in stand-by: Press briefly to switch the motor off.
RESET FILTERS SIGNALS
After having carried out maintenance of the filters, press this sensor key for 3 seconds. Flashing led 1 (fats filter)
or 2 (carbon filter) will stop flashing.
EXCLUDING THE ELECTRONICS
Press the key for 3 seconds. The hood command electronics will be excluded.
This function can be useful during the product cleaning operations.
Just repeat the operation to reinsert the electronics.
REMOTE CONTROL BATTERY CONTROL
When flashing, replace the battery on remote control.
Note: The front door must always be left closed and opened only for maintenance (e.g. cleaning or changing filters).
If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. by pulling out the
plug. Then plug it in again and try once more before contacting the Technical Assistance Service.