Zephyr AK1200CW, Инструкция по использованию, уходу и установке

Страница: 28 / 64

28 Breeze I & Breeze II Use, Care, and Installation Guide
B R E E Z E I &
B R E E Z E I I
U N D E R - C A B I N E T
C O R E
Troubleshooting
Possible Problem Possible Cause Solutions
After installation, the unit
doesn’t work. The power source is not turned ON. Make sure the circuit breaker and the unit’s
power is ON.
The power line and the cable locking
connector is not connecting properly. Check the power connection with the unit is
connected properly.
The switch board wirings are
disconnected. Make sure the wirings at the switch board are
connected properly.
The switch board is defective. Change the switch board.
Light works, but blower is
not turning. The blower cable is disconnected. Connect the blower cable.
Debris or obstruction in motor. Remove the debris or obstruction.
Motor defective or possibly seized. Change the blower.
Damaged capacitor. Change the capacitor.
The switch board is defective. Change defective part.
The unit is vibrating. The blower is not secured in place. Tighten the blower in place.
Damaged blower wheel. Replace the blower.
The hood is not secured in place. Check the installation of the hood.
The blower is working,
but the lights are not. The LED light connector is
disconnected. Connect the LED light connector.
Defective LED light. Change the LED light.
The switch board is defective. Change the switch board.
The hood is not venting
out properly. Using the wrong size of ducting.
Change the ducting to at least
3-1/4”x10”
or
higher or 7” round or higher (AK12 only).
Using the wrong type of ducting.
Flexible ducting can reduce air flow by
up to 50%. Change the ducting to solid rigid metal
ducting.
The hood might be hanging to high
from the cook top. Adjust the distance between the cooktop
and the bottom of the hood within 24” to 36”
for gas cooktops and 20” to 36” for electric
cooktops.
The wind from the opened windows or
opened doors in the surrounding area
are affecting the ventilation of the
hood. Close all the windows and doors to eliminate
the outside wind flow.
Blockage in the duct opening or
ductwork. Remove all the blocking from the duct work or
duct opening.
LumiLight LEDs flicker
when changing speed
levels. N/A This is a normal operation and the hood is
working correctly.