ZEP Pressure Washers, Руководство по обслуживанию

Страница: 23 / 36

23
Burner Maintenance
Oil Burner Maintenance
Oil Fired Cleaners
Air Band Adjustment
Note: The air band adjustment on this burner has been preset at the factor
(elevation approximately 1400 feet). On equipment installed where elevation
is substantially different, the air band(s) must be readjusted.
1. Loosen the cap screw retaining the air bands.
2. Move the air bands as indicated below with the machine in
operation. Note: The air band should be set so the exhaust
gives the smoke spot specified in the GENERAL section of the
MACHINE SPECIFICATIONS on a Shell-Bacharach scale. If a
smoke tester is not available, a smoky exhaust, oily odor, or sweet
smell indicates insufficient air while eye-burning fumes indicate too
much air.
3. Tighten the cap screw retaining the air bands.
Fuel Pump Filter
Sundstrand Pump
1. Shut off fuel supply.
2. Loosen the 4 screws holding the cover to the fuel pump housing.
3. Take cover and cover gasket off and pull strainer off of pump
housing.
4. Clean out any dirt remaining in the bottom of strainer cover. If
there is evidence of rust inside of the unit, be sure to remove water
in supply tank and fuel filter.
5. Turn on fuel supply. Failure to do so will result in fuel pump
damage.
Fuel Pump Pressure Adjustment
1. Install a 0-200 PSI Pressure Gauge.
2. Remove Plug on top of the fuel pump.
3. Insert a 1/8” Allen Wrench and turn clockwise to increase pressure
and counter clockwise to decrease.
4. Remove Gauge and reinstall plug.
Blower Fan Replacement
1. Shut off power to the burner and disconnect wires.
2. Loosen the two screws securing blower motor and fan to the
PART NUMBER
V00-14283-2
PART NUMBER
V00-14283-5