Page
13
of
15
and battery is tight; if the wire is loose, tighten and turn power on again. If pruner is
not working and you hear four continuous warning beeps, charge the battery
immediately.
5.
Don’t overload while cutting, as damage will occur.
6.
If the blade has been jammed by a branch, the blade will remain in maximum opening.
Caution: Don’t twist the pruner from the left to right when cutting as this will result in
damage to the blade.
7.
You can adjust the opening of the blade from large to small by pressing the black
button on the left hand side of the electric pruner.
8.
When you are done pruning press the trigger and hold 5 seconds; the blade will stay
closed. Turn off the power switch and pull out the cable from the battery.
Cleaning
：
•
Don’t flush tool or place in water, this will cause a short circuit and damage tool.
•
Keep motor and handle clean, always use a soft cloth to clean tool.
•
Don’t use cleanser to flush tool as it will rust parts.
•
Clean the blade after every use, protect with oil or spray protection.
•
Open front cover for cleaning the impurities (follow maintenance directions)
Adjusting Blade Clearance
：
Always check and adjust the clearance of blade to 0.1mm. Making sure proper clearance
will allow more efficient cutting. You can adjust the clearance by loosening the center
bolt adjustment gear clip. The adjustment is made by loosening or tightening the
adjustment gear nut. Once the desired adjustment is achieved, secure the gear clip back in
place.
Storage
：
•
Don’t dispose the battery in a hot or cold environment.
•
Remove battery from device if storing for a long time.
•
Store the battery and charger in original case to keep away from heat, dust and
humidity.
•
Check switch is in off position before storage.
Battery should be storage to dry environment, see below:
Storage less than 1 month
-4.0 F ~ 140.0 F
Storage less than 6 months
14.0 F ~ 95.0 F
Storage over 6 months
32.0 F~ 86.0 F
