Zenoah GZ3700EZ, Руководство оператора

Страница: 27 / 144

3. Pull out the starter rope approximately 30 cm/12 in.
4. Let the pulley rotate slowly rearward to release the
recoil spring.
5. Remove the screw (A), the rachet (B), and the pulley
(C).
A
B
C
WARNING:
You must be careful
when you replace the return spring or
the starter rope. The recoil spring is in
tension when it is wound up in the starter
housing. If you are not careful, it can
eject and cause injuries. Use protective
glasses and protective gloves.
6. Remove the used rope from the handle and pulley.
7. Attach a new starter rope to the pulley.
8. Make a tight knot at the end of the starter rope on
the pulley side.
9. Pull the starter rope through the hole in the starter
housing and the starter rope handle.
10. Attach the center screw in the center of the pulley.
11. Make a tight knot at the end of the starter rope on
the starter handle side.
To tighten the recoil spring
1. Put the starter rope into the pulley.
2. Turn the starter pulley approximately 5 to 6 turns
clockwise.
3. Put your thumb on the pulley.
4. Pull the starter rope handle and pull out the starter
rope fully.
5. Move your thumb and release the starter rope.
To assemble the starter housing on the
product
1. Pull out the starter rope and put the starter in
position against the crankcase.
2. Slowly release the starter rope until the pulley
engages with the pawls.
3. Tighten the screws that hold the starter.
To clean the air filter
Clean the air filter regularly from dirt and dust. This
prevents carburetor malfunctions, starting problems,
loss of engine power, wear to engine parts and more
fuel consumption than usual.
2218 - 004 - 31.08.2023 27