G2501 / G2501 OPS
GB-7
G
B
The port to refuel “MIX GASOLINE”
Position:
Fuel cap
The port to top up chain oil
Position:
Oil cap
Setting the switch to the “O” position, the engine stops immediately.
Position:
Front at the top of the rear handle
Starting the engine. If you pull out the choke knob (at the back-right of
the rear handle) to the point of the arrow, you can set the starting mode
as follows:
•
First-stage position – starting mode when the engine is warm.
•
Second-stage position – starting mode when the engine is cold.
Position:
Upper-right of the aircleaner cover
The screw under the “H” stamp is The High-speed adjustment screw.
The screw under the “L” stamp is The Slow-speed adjustment screw.
The screw at the left of the “T” stamp is the Idle adjustment screw.
Position:
Left side of the rear handle
If you turn the rod by screwdriver follow the arrow to the "MAX" position,
the chain oil flow more, and if you turn to the "MIN" position, less.
Position:
Bottom of the power unit
<G2501 One-push-start only>
A : Indicates the operation selecting position of the select lever for the
One-push-start and Super e-START at a start of the recoil.
B : Indicates the operating direction of the select lever at a start of the
engine by One-push-start.
Position:
Upper side portion of the recoil starter
2. Explanation of Symbols on the Machine
For safe operation and maintenance, symbols are carved in relief on the machine.
According to these indications, please be careful not to make any mistake.
B
A
WARNING
*01_G2501 G2501ops_GB_CS5_六.indd 7
16/09/21 16:49
