16
■
STARTING ENGINE
1. Rest the unit on a flat, firm place. Keep the
cutting head off the ground and clear of
surrounding objects as it will start rotating upon
starting of the engine.
2. Pump the primer until fuel flows out in the clear
tube. (OP1)
3. Move the choke lever upward to close the
choke. (OP2)
(1) Choke lever
(2) Close
(3) Open
4. Shift the ignition switch to the START position.
(OP3)
(1) Ignition switch
(2) Stop
(3) Start
5. While pulling the throttle lever with the little
finger of your left hand, pull the starter rope.
(OP4)
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause
starter failures.
6. When the engine has started, move the choke
lever gradually downward to open the choke.
7. Allow the engine to warm up for a half minute
before starting operation.
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start
due to excess fuel. When the engine failed to
start after several attempts, open the choke and
repeat pulling the rope, or remove the spark plug
and dry it.
NOTE
NOTE
8. Operation
OP1
OP2
OP3
OP4
Содержание BT225
Страница 20: ...20 9 Maintenance 8 11 14 1 2 9 10 12 13 15 THIS SIDE UP THIS SIDE UP WIND LINE...
Страница 26: ...12 Parts list 26 Fig 1 DRIVE UNIT BT225 S N 000001 and up...
Страница 28: ...Fig 2 ENGINE UNIT BT225 S N 50100000 and up 28 12 Parts list...
Страница 32: ...Printed in Japan KOMATSU ZENOAH AMERICA INC 4344 Shackleford Road Suite 500 Norcross Georgia 30093...