Zennio KNX-IP Router / Interface PLess
http://www.zennio.com
Technical Support:
http://support.zennio.com
8
In ETS4 this is configured by right-clicking on the line and, under "Set
Connection", selecting the desired connection.
Figure 4
ETS4 parallel downloads.
Note
:
once the connection has been selected, it will not be available for the other lines.
An additional restriction applies to parallel downloads: they are
not available to
download physical addresses
. When performing this type of downloads, the link
device used by ETS is not the one configured for the line but the general one.
1.3.2
LIMITATIONS
It is important to note that Zennio KNX-IP Router PLess and Zennio KNX-IP Interface
PLess, when being used as programmer, do not allow
bus monitoring
(the ETS bus
monitor will not be available).
Moreover, these devices do not allow being
unloaded (unprogrammed)
from ETS.
Equivalently, they can be reset to the factory default state, as explained in section
2.5.2.
