Zennio KNX-IP Router / Interface PLess
http://www.zennio.com
Technical Support:
http://support.zennio.com
18
2.6
WEB INTERFACE
Zennio KNX-IP Router PLess / Interface PLess provides a web interface for
consulting the device configuration
,
activating the programming mode
or
updating the firmware
.
The web interface can be accessed through port 8080 of the IP address of the device.
For example, if the IP address is 192.168.1.222:
http://192.168.1.222:8080
The following URLs
(where “xxxxxx” refers to the last six digits of the MAC address of
the device) will be equivalent:
Zennio KNX-IP Router PLess
: http://KNX-IPrt-xxxxxx:8080.
Zennio KNX-IP Interface PLess
: http://KNX-IPif-xxxxxx:8080.
The
IP address
of the device can be easily obtained in ETS as long as the device
belongs to the same LAN segment than the PC. On the other hand, the
MAC address
must be printed on the cover of the device.
Note
:
Zennio KNX-IP Router PLess allows using port 80 instead of 8080 by enabling it
in parameters
.
In such case, it can be omitted from the access URL
.
2.6.1
DEVICE INFO
The
“Device Info” tab in the web interface contains general information about the
current settings of the device, as Figure 8 shows.
Figure 8
Web interface (Device Info).
