Presentia W0
Technical Support:
5
1.2
INSTALLATION
Presentia W0 connects to the KNX bus through the on-board KNX connector.
Once the device is provided with power from the KNX bus, both the individual address
and the associated application program may be downloaded.
This device does not need any additional external power since it is entirely powered
through the KNX bus.
Figure 1.
Presentia W0. Elements
The main elements of the device are described next.
Programming button (5)
: a short press on this button sets the device into
the programming mode, making the associated LED (4) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the
device will enter the safe mode. In such case, the LED will blink in red every
0.5 seconds.
Detection notification LED (2)
: emits a light flash whenever the sensor
associated to that zone observes motion.
Note
:
for an optimal operation of the motion and luminosity sensors it is
recommended that this detection notification LED only be activated during the
installation process.
55,5
55
,5
40
32
55,5
55
,5
40
32
5
1
2
3
4
6
7
1.
Frame.
2.
Detection notification LED.
3.
Fixing clip.
4.
Programming LED.
5.
Programming button.
6.
KNX connector.
7.
Levelling plates (1 y 1,5mm)
