KLIC-MITT v2
Technical Support:
5
INSTALLATION
Figure 1.
Element scheme
KLIC-MITT v2 connects to the KNX bus via the corresponding built-in terminal (5).
Once the device is provided with power from the KNX bus, both the physical address
and the KLIC-MITT v2 application program can be downloaded.
This device does not need any external power as it is entirely powered through the
KNX bus.
The remaining elements are described next.
Prog./Test button (2)
: a short press on this button will set the device into the
programming mode, making the associated LED (1) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. The LED will blink in red every 0.5 seconds
Analogue-Digital Inputs (3)
: input ports for the stripped cables of external
elements such as switches, motion detectors, temperature probes, etc..
Communication cable (4)
: cable with a CN105/CN92 connector that will
connect KLIC-MITT v2 to the A/C unit. The other end of the cable, therefore,
is intended to be connected to the IT Terminal connector in the PCB board of
the internal unit.
1. Prog./Test LED indicator
2. Prog./Test button
3. Analogue/digital inputs
4. IT Terminal connection cable.
5. KNX connector
