Flat Sensato
Technical Support:
4
1.2
INSTALLATION
To install the device, it is first necessary to mount the metallic plate into a square/round
standard appliance box through the suitable screws. Next, Flat Sensato is connected to
the KNX bus through the corresponding terminal on the rear side of the device, and
then the input terminal is as well connected to the rear of the device.
Once the input terminal and the KNX terminal are connected, the device can be easily
mounted on the metallic plate by the action of the fixing clips.
Finally, it is advisable to check that the device is properly installed, and that only its
profile becomes visible from above, from below and from both sides (the metallic plate
should be completely hidden).
Figure 2 shows the connection outline of the device:
1.
Humidity notification LED
2.
KNX connector
3.
Sensor
4.
Programming LED
5.
Programming Button
6.
Inputs connector
7.
Fixing clips
Figure 2.
Schematic diagram
1
2
3
Figure 1.
Installation
1
3
2
7
5
4
6
