P A G E 1 4
206-3686
Hook Up S-Video VCR/DVD Player
S-Video cables
not included
with TV
Audio Out
S-Video
Out
3 4
VCR Back
VCR Back AV Panel
Output
Switch
R L
Typical
TV Back
S-Video In
M.P.I.
R Audio In L
S-Video Out
Antenna
Cable
Component Video Input
R Audio In L
R Audio L
Video In
Y
Pr
Pb
Matrix Out
Your Zenith TV may be connected to a Super-VHS VCR or DVD player through the S-Video
Input located on the TV’s connection panel. Use the TV’s S-Video In jack to connect other
S-Video type equipment. To use this equipment you must use the optional LP702 remote
control, go to the Source menu on page 21.
Hook up your S-Video type VCR or DVD
player to the TV according to the diagram.
Remove the back of the remote and put in
two AA batteries.
Plug in your TV. The TV is designed to
operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on
DC power.
If you wish to “daisy chain” more than
one TV to receive the S-Video signal, make
the following connections with an S-Video
cable. Insert one end of the cable into
S-Video Out and the other end into the
S-Video In jack on your second Zenith TV,
or equivalent input for any other brand of
TV. See page 17.
1
2
3
4
4
Back of
Remote
120 Volt
60 Hz AC
Note: S-Video loopout
must be enabled for this
feature to work. Refer to
Installers menu pages,
Installer menu item 33-I,
Y/C Loopout.
